Ideally matched to HiPace 300, Supply via drive electronics TC 110, TC 120 and TCP 350, Required installation elements included in scope of delivery, Can be directly connected with an M8 plug to the accessory outputs of the electronic drive unit
Ideally matched to SplitFlow 50/80, HiPace 60P and HiPace 80, Used with Tele-TC Cable 110, Supply via drive electronics TC 110, TC 120 and TCP 350, Required installation elements included in scope of delivery, Can be directly connected with an M8 plug to the accessory outputs of the electronic drive unit
Suitable for use HiPace 80 Neo, Intelligent accessory detection, Flexible positioning, Required installation elements included in scope of delivery, Can be directly connected to accessory outputs C1 or D1 with Micro USB plug
The air venting valve is installed on the pump exhaust port, Allows to reduce the braking time fo the pump, The purge of this valve may be isolated during an air tightness test, For ATH 500 M
Air venting valves, for Magpower and OBC V4, The air inlet valve is installed on the pump exhaust port, Allows to reduce the braking time fo the pump, The valve is powered by the controller. 11 slm flow rate., The valve is activated wen the pump speed is below 10,000 rpm., The valve is normally closed. May be used with dust filter
With metal seals a vacuum of 10E-9 hPa can be achieved, No gas permeation, For stainless steel flanges, Fastener: ISO-KF clamp for metal seals, For single use only
Don't worry we won't leave you in a vacuum
