Venting

The air venting valve is installed on the pump exhaust port, Allows to reduce the braking time fo the pump, The purge of this valve may be isolated during an air tightness test, For ATH 500 M

Air venting valves, for Magpower and OBC V4, The air inlet valve is installed on the pump exhaust port, Allows to reduce the braking time fo the pump, The valve is powered by the controller. 11 slm flow rate., The valve is activated wen the pump speed is below 10,000 rpm., The valve is normally closed. May be used with dust filter

For mounting of venting/sealing gas valves, Connection G 1/8"

For installation of flood/sealing gas valves for small spaces, G 1/8" connection

Screw on flange DN 16 ISO-KF including seal, For connection to venting valves, sealing gas valves, power failure venting units or sealing gas throttles, G 1/8", SW 17

Hose nozzle incl. seal, For connection to e. g. venting valves, sealing gas valves or power failure venting units or driers, Connection G 1/8", For 9 mm hose

Cable with M8 plug for connection to TC 110/120 included in the shipment, Normally opened valve, Venting mode, venting time and venting period adjustable via electronic drive unit and DCU/HPU, G 1/8" connection on both sides, Can be directly connected to the accessory outlets of the connection cable, TCS 12/13 as well as TC 110/120 with interface (PB, E74, RS)

Cable with M12 plug for connection to TC 400, TM 700, TCP 350 and TC 1200 included in scope of delivery, Normally opened valve, Venting mode, venting time and venting period adjustable via electronic drive unit and DCU/HPU, G 1/8" connection on both sides, Can be connected directly to the accessory outputs of the drive electronics unit

Push-in fitting including seal, For connection to e. g. venting valves, sealing gas valves or power failure venting units or driers, Connection G 1/8", For 6 mm hose